Additional Information

Air Compressor 200ltr V-Twin Belt Drive Draper 77002 DA200/300C

Before attempting to operate the Draper 77002 DA200/300C Air Compressor 200ltr V-Twin Belt Drive, carefully read through the entire instruction manual, to understand the applications limitations and potential hazards associated with this air compressor. Failure to do so could lead to serious personal injury. Take  note of the important safety instructions. Your air compressor has many features that will make your job faster and easier. Performance and dependability have been given top priority in the development of this tool, making it easy to maintain and operate.

Draper air compressors have been carefully tested and inspected before shipment and are guaranteed to be free from defective materials and workmanship for a period of 12 months from the date of purchase.

Air compressors are potentially dangerous equipment, which if not used correctly can cause serious injury to the user. The user bears sole responsibility for any damage or injury that may result from the use of the compressor for any purpose other than it was intended. Air compressors should not be operated by persons under 16 years of age, or persons whose stature and strength will prevent the safe operation of the compressor.

Air tools require lubricant so that the internal moving parts are lubricated. This can be done by placing a few drops of oil in the air inlet fitting on the bottom of the tool. This should be done on a daily basis or whenever the tool is used. It is also recommended that an air filter lubricator is used. An air filter is a device which removes contaminants from a compressed air stream. Moisture can condense in the air compressor so it is extremely important to drain the tank after each days use, also the filter regulator. If left in the tank moisture could accumulate and rust and weaken the tank, also this moisture could find its way along the airline and into the tool and affect the performance of the tool. If these steps are carried out the working life of the tool will be prolonged. This will ensure optimum performance. Safety glasses should always be worn when working with air tools to protect from flying debris such as particles of metal, rust, dirt and grime.

Be sure to take into account the CFM (Cubic Feet per Minute) requirements of your air tool or the equipment you intend to use, which will need to be lower than the CFM of your compressor. High CFM ratings mean a compressor can provide more air, making higher CFM units more practical for larger applications.

ELECTRICAL SAFETY

Power tool plugs must match the outlet. Never modify the plug in any way. Do not expose power tools to rain or wet conditions. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. When operating a power tool outdoors, use an extension lead suitable for outdoor use.

The Royal Society for the Prevention of Accidents (RoSPA) recommends the use of an RCD to reduce the risk of fatal shock. For electrical safety it is recommended to always fit an RCD when you use power tools. You can have an RCD fitted to protect a particular circuit as part of the socket outlet between the socket outlet and the equipment being used. For greater safety when using electrical equipment use a residual current device (RCD). Care in use is still necessary.

Stay alert, watch what you are doing and use common sense when operating this equipment. Do not use when you are under the influence of drugs, alcohol or medication. A moment of inattention while operating the compressor may result in serious personal injury.

Draper 77002 DA200/300C Air Compressor 200ltr V-Twin Belt Drive - Instructions